EasyManuals Logo

DANIEL 2500 User Manual

Default Icon
162 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
MODELMODEL 2500_______________________________________________________2500_______________________________________________________
MODEL 2500 DISPLAY SCREEN
The DANIEL INDUSTRIES MODEL 2500 INSTRUMENTATION SYSTEM
MICROCOMPUTER front panel has a LCD screen located at the top of the front
panel which is electro-luminescent backlighted for readability under various
ambient lighting conditions.
This screen displays two lines of alphanumeric characters with 16 characters in
each line, which provide for the readout of data, system command and prompts,
and computation results. Numeric values are displayed in appropriate engineering
units when applicable.
The display also has an adjustable viewing angle so that instruments, which are
mounted either at a relatively low or high height, may be adjusted for comfortable
viewing.
To adjust the LCD for comfortable viewing after installation:
- Release the catch located at the bottom of the panel
- Pull the display unit forward approximately one inch
- Locate the small potentiometer on the left hand side of the display
board in the center, approximately 1/2 " from the front, as illustrated
below. With a small screwdriver adjust the angle for the most
comfortable viewing.
________________________________________________________________________________________________________________________________________
SECTIONSECTION 22
9

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DANIEL 2500 and is the answer not in the manual?

DANIEL 2500 Specifications

General IconGeneral
BrandDANIEL
Model2500
CategoryComputer Hardware
LanguageEnglish