DANIEL 2500 - Restricted-User Password

MODELMODEL 2500_______________________________________________________2500_______________________________________________________
RESTRICTED-USER PASSWORD
The restricted-user password provides an additional level of security for
user-specified, limited-access variables. The restricted-user password may not be
entered until the lower-level password is activated.
Until the restricted-user password is entered, limited-access variables can be
displayed, but cannot be changed, regardless of the state of the lower-level
password. After the restricted-user password is entered, limited-access variables
can be changed.
If the three-position security switch is in the center position, the restricted-user
password remains active for five minutes after the last key is pressed. In this
switch position, the system command "Unit Lock" disables the restricted-user
password and the lower-level password.
If the three-position security switch is in the up position, the restricted-user
password will not automatically time-out after five minutes, and must be disabled
using the "Unit Lock" command.
The factory-installed restricted-user password is "11111111". A new,
user-originated, restricted-user password should be entered at initial startup.
_________________________________________________________
CAUTION! Since neither the standard-unit password, nor the
restricted-user password can be retrieved after
being entered, a record of each should be kept in
a secure location for future reference. However,
the standard unit password may be over-written
if the security switch is in the down position.
_________________________________________________________
________________________________________________________________________________________________________________________________________
SECTIONSECTION 33
35