MODELMODEL 2500_______________________________________________________2500_______________________________________________________
DISPLAYING A LIVE VALUE WHEN THE VARIABLE HAS BEEN
MANUALLY OVERRIDDEN
The steps involved in displaying a LIVE value on the MODEL 2500 LCD screen
when the variable has been manually overridden are as follows:
- Begin with the following illustrated display screen message.
30. DEGF
C3TEMP MANUAL
- Press the ENTER key to monitor the LIVE value of the variable, and
then press the DOWN arrow key to change to the following illustrated
display screen.
C3TEMP LIVE
20.0 DEGF
This display is useful when instruments are being serviced, because
the value displayed is unaffected by manual override. This means that
the actual value of a variable can be monitored during system
calibration or troubleshooting procedures even though the live value
has been manually overridden, and an operator-entered value is being
used for calculations.
________________________________________________________________________________________________________________________________________
SECTIONSECTION 66
93
To Next Page
Loading...
Need help?
General