____________________________________________________________________________________________________________ MODELMODEL 25002500
MODELMODEL 25002500 SOFTWARESOFTWARE
The DANIEL INDUSTRIES MODEL 2500 specialized application software is
developed in conjunction with the CONFIG25 program. The CONFIG25 program
is designed to run on an IBM PC or compatible personal computer.
This manual provides the basic operational information to download and operate
software in the MODEL 2500, which contains a Revision 5.00 level or higher. The
new generation of BASE25 allows the user to download any Revision K.2 or
higher applications without requiring a new analysis of an application under a
different Config25.
Prior to Revision 5.00 baseline, applications had to be developed, analyzed, and run
on software that was of the same revision level. Revision 5.00 and higher
firmware (hereafter referred to as 5.nn), is designed to support applications
developed on multiple Daniel CONFIG25 software releases.
The following table lists the CONFIG25 software releases that are supported and
the baseline used for execution. The following compatibility rules are imposed by
the download routine.
CONFIG25
Revision
Release
Date
Compatible BASE25 Revisions
K.2 L.7 L.8 N 5.nn
K.2 12/86 yes no no no yes
L.7 6/87 no yes yes yes yes
L.8 10/87 no yes yes yes yes
N 2/88 no no no yes yes
5.nn 12/89 no no no yes yes
________________________________________________________________________________________________________________________________________
SECTIONSECTION 11
6
To Next Page
Loading...