____________________________________________________________________________________________________________ MODELMODEL 25002500
SERIAL PORTS
The SERIAL PORTS sub-menu, which is the tenth sub-menu on the MAIN
MENU, is categorized by, and divided into one-board units and two-board units.
One-board units have thirteen lower level sub-menus, which are COMMID
BAUD1, BAUD2, PORTUSE1, PORTUSE2, PARITY1, PARITY2, STOPBIT1,
STOPBIT2, PRTCLSLV, PRTCLMAS, RPTGAP, and COMMWAIT.
Two-board units have twenty lower level sub-menus, which are COMMID,
COMMID2, BAUD1, BAUD2, BAUD3, PORTUSE1, PORTUSE2, PORTUSE3,
PARITY1, PARITY2, PARITY3, STOPBIT1, STOPBIT2, STOPBIT3,
PRTCLSLV, PRTCLSLV2, PRTCLMAS, RPTGAP, COMMWAIT AND
COMMWAIT2.
_________________________________________________________
NOTE! Applications with reports exceeding one page require
that the printer has an 8k buffer capacity, or the baud
rate of the printer output signal is lowered to 300 with
the RPTGAP lower level sub-menu set to SPACES.
This note applies to BAUD1 and BAUD2 of the
SERIAL PORTS sub-menu for one-board units and
BAUD1, BAUD2, and BAUD3 of the SERIAL PORTS
sub-menu for two-board units.
_________________________________________________________
________________________________________________________________________________________________________________________________________
SECTIONSECTION 44
52
To Next Page
Loading...
Need help?
General