____________________________________________________________________________________________________________ MODELMODEL 25002500
TYPICAL START-UP DATA CHANGES
The following list represents data that is often changed from the factory-installed
default values at the initial start-up of a MODEL 2500 configured for a specific
application:
- Measured or hand-entered values of process variables
- Definitions of the metering arrangement, including:
- Flange or pipe-tap differential pressure transmitters
- Upstream or downstream static pressure transmitters
- Single or dual-range differential pressure transmitters
- Settings for zero (4 mA) and full-scale (20 mA) values (in engineering
units) of transmitter inputs
- Desired multipliers for readouts of flow rates and flow accumulators
- High and low alarm limits
- Calibration units for frequency-type densitometers
- Base values for temperature and pressure
- Barometric pressure for the measurement site
- Unit ID number for printout identification
- Time and date
- Contract hour and time period between printouts
________________________________________________________________________________________________________________________________________
SECTIONSECTION 33
40
To Next Page
Loading...
Need help?
General