DANIEL 2500 - Page 69

To Next Page

To Previous Page

MODELMODEL 2500_______________________________________________________2500_______________________________________________________

PARITY1 PARITY1 lower level sub-menu provides for displaying

or changing the parity of serial port number 1 (EVEN,

ODD, NONE), with the default parity being EVEN.

PARITY2 PARITY2 lower level sub-menu provides for displaying

or changing the parity of serial port number 2 (EVEN,

ODD, NONE), with the default parity being EVEN.

PARITY3 PARITY3 lower level sub-menu provides for displaying

or changing the parity.

STOPBIT1 STOPBIT1 lower level sub-menu provides for displaying

or changing the number of stopbits transmitted from

serial port number 1 (1, 1 1/2, 2), with the default stopbit

setting being 1.

STOPBIT2 STOPBIT2 lower level sub-menu provides for displaying

or changing the number of stopbits transmitted from

serial port number 2 (1, 1 1/2, 2), with the default stopbit

setting being 1.

STOPBIT3 (Two-board units only) STOPBIT3 lower level sub-menu

provides for displaying or changing the number of

stopbits transmitted from serial port number 3 (1, 1 1/2,

2), with the default stopbit setting being 1.

PRTCLSLV PRTCLSLV lower level sub-menu provides for displaying

or changing the type of communications used by any one

of the serial ports, which is defined in the portuse section

as a SLAVE (MODASCII or MODRTU), with the default

type being MODASCII.

PRTCLSLV2 (Two-board units only) PRTCLSLV2 provides the same

function as PRTCLSLV for two-board units.

________________________________________________________________________________________________________________________________________

SECTIONSECTION 44