Datalogic Dragon

DRAGON™
144
5
The message is sent in the following format:
"Message" CR LF
5.3.3 Master Header/Terminator Selection
In addition to the standard header/terminator selection, the Master cradle can add its
own header/terminator to the entire message sent to the Host.
In the STAR-System™ network headers and terminators for all RF Devices are
disabled by default.
The Master header and terminator default values are as follows depending on the
interface selection towards the Host:
RS232: no header, terminator CR-LF
WEDGE: no header, terminator ENTER
See par. 5.4.1 and 5.4.2.
5.4 DATA FORMAT
For an overview of Message Formatting see Chapter 6.
5.4.1 Header/Terminator Selection
The header/terminator selection is not effected by the reading of the restore default
code. In fact, header and terminator default values depend on the interface selection:
RS232: no header, terminator CR-LF
WEDGE: no header, terminator ENTER
These default values are always
restored through the reading of RS232 or WEDGE
interface selection code, see par. 4.7.