Datalogic Dragon - Using Multiple M-Series Readers with same Cradle

CONFIGURATION
25
4
8.
Firmly insert the reader into the OM-DRAGON™ cradle within 10 seconds, a
beep will be emitted, signaling that the OM-DRAGON™ cradle has been paired
to the DRAGON™ M, and the green LED on the reader will go off.
Read the OM-DRAGON™ restore default code:
9.
Restore OM-DRAGON™ default
i39Rk
i39Rk
i39Rk
Go to par. 4.7 Interface Selection.
4.4.1 Using Multiple M-Series Readers With Same Cradle
If you want to use several M-Series readers with the same OM-DRAGON™ cradle,
you must first Bind the cradle with one of the readers (see previously described
configuration procedure).
Successive readers
can be associated with the same cradle by following the
configuration procedure substituting the Bind command with Join (step 7).
7.
Join
i3//k
i3//k
i3//k
The green LED on the DRAGON™ M will blink: the reader is ready to be
inserted into the cradle. Complete step 8.
END of procedure.
Green LED