DRAGON™
152
5
5.8.2 Power-Off Timeout
If this command is enabled, after the desired timeout in hours, the DRAGON™
batteries are disconnected and all power consumption ceases. To restore power,
press the trigger once. The reader will now be ready to read codes.
Power-off does not effect configuration parameters.
5.8.3 Transmission Mode
This parameter determines whether the reader receives responses or messages from
the Host or not. In One-Way tx mode, neither Host nor cradle responds to the reader.
In Two-Way tx mode, the reader must
receive a response from either the cradle or
the Host.
The cradle responds (empty message) to the reader, only after good transmission to
the Host, for the following conditions: ACK/NACK enabled, see par. 5.1.2; WEDGE or
PEN interface. For these conditions, it is suggested to prolong the Radio Protocol
Timeout, see par. 5.8.1.
Enabling Two-Way tx mode temporarily disables FIFO buffering see par. 5.1.3.
With ACK/NACK disabled, the Host responds to the reader (through the cradle) with
an answer message (message to reader display or command to reader), see par. 6.1
and the following figure.
OM-DRAGON™
Host
data
cable
DRAGON
M
data
Transmission Mode = Two-Ways
Host answer message Host answer
message
To Next Page
Loading...
Need help?
General
