To Next Page

To Previous Page

Enter configuration

ik

DATA FORMAT

Exit & Save configuration

i k

CHARACTER REPLACEMENT

 disable character replacement

i&0Nk

This parameter allows up to three characters to be replaced from the barcode read. These

substitutions are stored in memory. To define each

character replacement:



Read one of the following character replacement codes:

first character replacement

☞

i&0Qk

second character replacement

☞

i&0Tk

third character replacement

☞

i&0Wk

 From the Code Identifier Table in Appendix B, read the Code Identifier for the desired

code family.

0 = character replacement will be effective for all code families.

 From the Hex/Numeric Table read two characters corresponding to the Hex value which

identifies the character to be replaced. Valid values for all readers are in the range 00-FE.

 From the Hex/Numeric Table read two characters corresponding to the Hex value which

identifies the new character to replace. Valid values for all readers are in the range 00-FE.

FF = the character to be replaced will be substituted with no character, that is, it will be

removed from the code.

Datalogic Dragon User Manual

Questions and Answers: