ADVANCED SCANNER CONFIGURATION
The ADVANCED configuration mode (instead of the Wizard) is available when starting the
Genius program and is addressed to expert users being able to complete a detailed scanner
configuration. By choosing this option it is possible either to start a new scanner configuration
or to open and modify an old one. The desired parameters can be defined in the following
window, similar to the MS Explorer:
Figure 13 - Genius Parameter Explorer Window
Host Mode Programming
The scanner can also be configured from a host computer using the Host Mode
programming procedure, by commands via the serial interface. See the Host Mode
Programming manual on the downloadable Genius mini-DVD zip file.
Alternative Layouts
The ID-NET network is a built-in high-speed interface dedicated for high-speed scanner
interconnection. ID-NET is in addition to the Main and Auxiliary serial interfaces. If you
need to install an ID-NET network refer to chapters 4 and 5 of this Reference Manual.
The scanner can also be configured by reading programming barcodes. See the "Setup
Procedure Using Programming Barcodes" printable from the downloadable Genius mini-
DVD zip file.
If you need to install an Ethernet network, Fieldbus network or Pass-Through network,
refer to chapters 4 and 5 of this Reference Manual.
To Next Page
Loading...
