DS5100-x4xx models can only be integrated into EBC networks as slave scanners where
SC5000 is the Master Controller. To do this:
1. Physically mount and electrically connect the DS5100 scanner in the application.
2. To set the DS5100 scanner as an EBC Slave, follow the EBC network selection
procedure described in step 4, X-PRESS Configuration.
3. Run Discovery from the SC5000 System Info page to discover all scanners in the
network.
NOTE: The DS5100 scanners can also be added to the EBC network using
the Add button in the SC5000 GUI.
To Next Page
Loading...
Need help?
General
