Laser and Product Safety
Product Reference Guide 1-13
Safety precautions to be taken:
Canadian Notice
This equipment does not exceed the Class B limits for radio noise emis-
sions as described in the Radio Interference Regulations of the Canadian
Department of Communications.
Le present appareil numerique n’emet pas de bruits radioelectriques depas-
sant les limites applicables aux appareils numeriques de la classe B pre-
scrites dans le Reglement sur le brouillage radioelectrique edicte par le
ministere des Communications du Canada.
CAUTION
No adjustments or alteration of the scanner or scanner/scale housing are to
be attempted by the user.
The failure of the facet wheel motor while the unit is continuing to emit a
laser beam causes the emission levels to exceed those for inherently safe
operation. The unit has safeguards to prevent this occurrence. If, however, a
stationary laser beam is ever emitted, the failing unit should be disconnected
from its power supply until repaired by a qualified technician.
WARNING
This equipment has been tested and found to comply with the limits for a
Class B digital device pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. How-
ever, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio or television technician for
help.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
