Datalogic MAGELLAN 8300 Product Reference Guide

System Power-Up Recap
Product Reference Guide 2-39
System Power-Up Recap
The System Power-Up procedure may vary depending upon the require-
ments of your POS system. It is generally a good practice to power-down
(switch off) all equipment prior to connecting cables. Check with your
System Supervisor and/or refer to your POS terminal manual for proper
power-down and power-up procedures and interface requirements when
connecting any peripheral device.
If you have not identified any specific requirements for your POS system,
follow these steps.
1. Power-down the POS terminal.
2. Ensure that power is disconnected from the scanner.
3. Connect the scanner and scale interface cables to your POS termi-
nal. This connection may use one or two cables depending upon
your POS terminal interface.
4. [EAS units ONLY] Connect the EAS interface cable.
5. Connect the Remote Display cable if your model is a scanner/scale
and make any connections to optional equipment, such as a hand-
held scanner.
NOTE
SENSORMATIC EAS SYSTEMS:
Always Apply power to the EAS Controller box before powering on the scan-
ner.

Datalogic MAGELLAN 8300 Specifications

General

Read rate (max)	3900 reads/s
Decoding standards	1D, GS1 DataBar
Standard interfaces	Keyboard Wedge, RS-232
USB 2.0 ports quantity	1
Input voltage	100 - 250 V
Product color	Metallic
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %

Weight and Dimensions

Depth	102 mm
Width	292 mm
Height	130 mm