Code Setup
1. Click on the Code Setup button. By default, the Data Matrix ECC 200 symbology is
enabled. If this symbology is among those in your application it will be shown in the
image display with its code symbology name and a small green box around it indicating it
is decoded.
NOTE: The large green box for each symbol indicates the code locator area
which by default is equal to the maximum FoV. It can be resized and moved
by dragging its borders with the mouse. The code must be found within this
area in order to be decoded.
2. Add your application specific codes to the Code Settings by selecting them from the icons
over the Configuration Parameters tree area. If the Data Matrix symbology is not used,
then delete it from the Code Settings with the icon.
If you don’t know the code type, you can use the Code Autolearn feature by clicking on
the icon.
3. For each code symbology set the relative parameters according to your application.
The Code Autolearn procedure will not recognize the following symbologies: Pharmacode, MSI, Standard 2 of 5, Matrix 2 of 5.
To Next Page
Loading...
