Datalogic Matrix 300N - Restore; Replacement

MATRIX 300N™ REFERENCE MANUAL
46
2
2.4.2 Restore
To perform a Restore:
1. Select either “Restore” (from file on PC) or "Restore from external storage device" from
the DL.CODE Device menu
If restoring an ID-NET network though the Master, this may take a few minutes.
At the end of the restore, DL.CODE shows a message indicating successful completion.
2.4.3 Replacement
CAUTION: The replacement device must be the exact same model as the
device it is replacing.
The Restore function also provides easy and secure Single Device Replacement:
1. Remove the device to be replaced.
2. Connect the new device (make sure the new device has been previously set to factory
default).
3. Run the Restore procedure by selecting either “Restore” (from file on PC) or "Restore
from external storage device" item (see: Restore procedure).
NOTE: For ID-NET network Backup and Restore, select the Backup
Current Cluster Configuration and Cluster Replacement selections.
NOTE: In case of Backup or Restore operation failures, error messages will
be displayed in the Monitor Diagnostic page.