Enter/Exit Programming Mode 2D Global Features
176
PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
2D Global Features
The following features are common to all, or in some cases, most of the
available 2D symbologies. Default settings are indicated at each feature/
option with a green arrow. Also reference Appendix C, Standard Defaults for
a listing of the most widely used set of s
tandard factory settings. That sec-
tion also provides space to record any custom settings needed or imple-
mented for your system.
To set most features:
1. Scan the ENTER/EXIT PROGRAMMING bar code at the top of applicable
programming
pages.
2. Scan the correct bar code to set the
desired programming feature or
parameter. You may need to cover unused bar codes on the page, and
possibly the facing page, to ensure that the reader reads only the bar
code you intend to scan.
3. If additional input parameters ar
e needed, go to Appendix D, Keypad,
and scan the appropriate characters from the keypad.
Additional information about many features can be found in the
“References” chapter.
If you make a mistake before the la
st character, scan the CANCEL
bar code to abort and not save the entry string. You can then start
again at the beginning.
Complete the programming sequence by scanning the ENTER/EXIT PRO-
GRAMMING bar code to ex
it Programming Mode.
To Next Page
Loading...
Need help?
General
