Enter/Exit Programming Mode
40
PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
Enable Character
Specifies the value of the RS-232 host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
Setting to previously defined characters such as XON, XOFF, or host commands con-
flicts with normal operation
of these characters.
See page 285 in “References” for more information on setting this feature.
Select Enable Character Setting
DEFAULT
0x45 = Enable Character is ‘E’
To Next Page
Loading...
