Datalogic PowerScan 9501-AR Series - Set Key Sequence Header; Set Key Sequence Terminator

Enter/Exit Programming Mode
276 PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
Set Key Sequence Header
Sets the header for keyboard composed strings.
Set key sequence header
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by 32 digits from the Alphanu-
meric characters in
Appendix D, Keypad . The
digits must be the hexadecimal ASCII representation
of t
he desired characters.
If less than the expected string of 16 characters are
sel
ected, scan the ENTER/EXIT bar code to termi-
nate the string.
If the first 2 digits are 0, the feature is disabled. End
by scanning the ENTE
R/EXIT bar code again.
Set Key Sequence Terminator
Sets the terminator for keyboard composed strings.
Set key sequence terminator
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by 32 digits from the Alphanu-
meric characters in
Appendix D, Keypad . The
digits must be the hexadecimal ASCII representation
of t
he desired characters.
If less than the expected string of 16 characters are
sel
ected, scan the ENTER/EXIT bar code to termi-
nate the string.
If the first 2 digits are 0, the feature is disabled. End
by scanning the ENTE
R/EXIT bar code again.