Enter/Exit Programming Mode
244
PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
BC9xxx Base
The BC9xxx can be changed from Normal to Compatible mode using the
Aladdin configuration tool. See "Datalogic Aladdin™" on
page 6 for more
information. This will allow you to Join or Bi
nd a PM8500 to your BC9xxx.
Changing from Compatible Mode back to Normal
PM9501-AR Handheld
1. With the PM9501-AR, read a Compatible mode programming label on
page 243 with a value of “Low, Medium,
or High Speed”.
2. With the PM9501-AR, read the Unlink programing label.
3. Now you can link your PM9501-AR to a BC9xxx in normal mode; the
PM9501-AR will inherit the programmed speed from the BC9xxx.
BC9xxx Base
1. Using Datalogic Aladdin, change the Compatible Mode parameter to
“Low, Medium, or High Speed”.
2. Now you can link a previously unlinked PM9501-AR; the reader will
i
nherit the speed programmed in the BC9xxx.
If Aladdin is not available, use the following procedure:
1. With a PM9501-AR in normal mode, r
ead the Unlink programming label
on page 20, then read the following
bar code:
Do not scan an ENTER/EXIT PROGRAMMING MODE label with this bar
code.
2. Place the same PM9501-AR on your BC9xxx.
Your BC9xxx will link to the PM9501-AR and will inherit the reader’s pro-
grammed speed.
Return to Normal
To Next Page
Loading...
