Enter/Exit Programming Mode
60
PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
Individually Set Label ID
This feature configures a Label ID individually for a single symbology. To
set, first define whether you want it as a prefix or suffix by scanning a label
below. Then turn to "Label ID Symbology Selection − 1D Sy
mbologies" on
page 61 to select the symbology you want to set, followed by up to 3 char-
acters from the ASCII Chart at the back of this manual. See "Label I
D: Set
Individually Per Symbol
ogy" on page 297 for detailed instructions on setting
this feature.
Label ID Control
This option controls whether a Label ID is disabled, or sent as a prefix or
suffix for a given symbology type.
Label ID Transmission = Disable
Label ID Transmission = Enable as Prefix
Label ID Transmission = Enable as Suffix
To Next Page
Loading...
Need help?
General
