Datalogic PowerScan 9501-AR Series

Enter/Exit Programming Mode
Product Reference Guide 217
Send Batch
When the scanner is configured in Manual Batch Mode, use the following bar
code to initiate sending of labels stored in batch memory.
Send Batch
Do not scan an ENTER/EXIT PROGRAMMING MODE label in con-
junction with this bar code.
Erase Batch Memory
When the scanner is configured in Manual Batch Mode, use the following bar
code to erase any labels stored in batch memory.
Erase Batch Memory
Do not scan an ENTER/EXIT PROGRAMMING MODE label in con-
junction with this bar code.