Enter/Exit Programming Mode
Product Reference Guide
233
Bluetooth Friendly Name
You can set a meaningful name for PowerScan BT9501-AR that will appear
in the application during device discovery.
To set a new Bluetooth Friendly Name, scan the barcode below and follow
th
e instructions.
Set Bluetooth Friendly Name
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by a maximum 64 digits from
the Alphanumeric characters in
Appendix D,
Keypad
. The digits must be the hexadecimal ASCII
representation of the desired characters. If less than
t
he expected string of 32 characters are selected,
scan the ENTER/EXIT bar code to terminate the
string.
Make a mistake? Scan the CANCEL bar code t
o abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
POWERSCAN BT9501-AR
[SERIAL_NUMBER_SCANNER]
Bluetooth Reconnect Attempt Mode
Enable/Disable reconnection by trigger pull.
Bluetooth Reconnect Attempt Mode = Disable
Bluetooth Reconnect Attempt Mode = Enable
To Next Page
Loading...
Need help?
General
