Enter/Exit Programming Mode
46
PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
Wedge Quiet Interval
Specifies amount of time to look for keyboard activity before scanner breaks
keyboard connection in order to transmit data to host. The selectable range
for this setting is 00 to 990 milliseconds (00-0x63 by 01) in increments of
ten milliseconds.
See page 286 in “References” for detailed information and
examples for setting this feature.
Set Wedge Quiet Interval
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then
the bar code at left followed by the digits from
the Alphanumeric characters in
Appendix D,
Keypad representing your desired character(s).
End by scanning the ENTER/EXIT bar code
aga
in.
Make a mistake? Scan the CANCEL bar code to
abor
t and not save the entry string. You can
then start again at the beginning.
CANCEL
DEFAULT
0A = Quiet Interval is
100 milliseconds
To Next Page
Loading...
Need help?
General
