Datalogic PowerScan 9501-AR Series

DEFAULT
F4 No Actions Configured
Configure Actions for F4
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code for the Function Key you want to program. Next
scan 4 digits from the Alphanumeric characters in
Appendix D, Keypad .
The first digit must be 0; the following 3 digits must
be con
figured according to the CMD_ID numbers in
Table 27 on page 257 . End by scanning the
ENTER/EXIT bar code again.
Enter/Exit Programming Mode
Product Reference Guide 261
Configure Actions for F4 (16-key models only)
DEFAULT
Shift No Actions Configured
Configure Actions for Shift
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code for the Function Key you want to program. Next
scan 4 digits from the Alphanumeric characters in
Appendix D, Keypad .
The first digit must be 0; the following 3 digits must
be con
figured according to the CMD_ID numbers in
Table 27 on page 257 . End by scanning the
ENTER/EXIT bar code again.
Configure Actions for Shift (16-key models only)