Enter/Exit Programming Mode
Product Reference Guide
31
RS-232/USB-COM INTERFACES
INTERCHARACTER DELAY on page 32
BEEP ON ASCII BEL on page 33
BEEP ON NOT ON FILE on page 33
ACK NAK OPTIONS on page 34
ACK CHARACTER on page 35
NAK CHARACTER on page 35
ACK NAK TIMEOUT VALUE on page 36
ACK NAK RETRY COUNT on page 37
ACK NAK ERROR HANDLING on page 38
INDICATE TRANSMISSION FAILURE on page 38
DISABLE CHARACTER on page 39
ENABLE CHARACTER on page 40
The programming bar codes in this chapter allow modifications to the stan-
dard RS-232 and USB-Com in
terfaces. Reference Appendix C, Standard
Defaults for a listing of standard factory settings.
To Next Page
Loading...
Need help?
General
