Dell Force10 TeraScale E Series - Page 1161

Private VLAN (PVLAN) | 1161
If the VLAN ID is that of a primary VLAN, then the entire private VLAN output will be displayed, as
shown in Figure 45-3. If the VLAN ID is a secondary VLAN, only its primary VLAN and its particular
secondary VLAN properties will be displayed, as shown in Figure 45-4.
Figure 45-3. Output of show vlan private-vlan (primary)
Figure 45-4. Output of show vlan private-vlan (secondary)
The table, below, defines the fields in the output, above.
Related
Commands
Table 45-2. show interfaces description Command Example Fields
Field Description
Primary Displays the VLAN ID of the designated or associated primary VLAN(s)
Secondary Displays the VLAN ID of the designated or associated secondary VLAN(s
Type Displays the type of VLAN in which the listed interfaces reside
Active States whether the interface is operationally up or down
Ports Displays the interface IDs in the listed VLAN.
FTOS# show vlan private-vlan community
Primary Secondary Type Active Ports
------- --------- --------- ------ ------------------------
10 primary Yes Gi 2/1,3
101 community Yes Gi 2/7-10
20 primary Yes Po 10, 12-13
Gi 3/1
201 community No
202 community Yes Gi 3/11-12
FTOS# show vlan private-vlan interface Gi 2/1
Primary Secondary Type Active Ports
------- --------- --------- ------ ------------------------
10 primary Yes Gi 2/1
FTOS# show vlan private-vlan 10
Primary Secondary Type Active Ports
------- --------- --------- ------ ------------------------
10 primary Yes Gi 2/1,3
1020 isolated Yes Gi 0/4
101 community Yes Gi 2/7-10
FTOS#show vlan private-vlan 102
Primary Secondary Type Active Ports
------- --------- --------- ------ ------------------------------------------
10 Primary Yes Po 1
Gi 0/2
102 Isolated Yes Gi 0/4
private-vlan mode Set the mode of the selected VLAN to either community or isolated.
show interfaces private-vlan Display type and status of PVLAN interfaces.