Dell Force10 TeraScale E Series - Page 1570

1570 | E-Series Debugging and Diagnostics
www.dell.com | support.dell.com
show hardware rpm mac counters
e
Display receive- and transmit-counters for the party-bus control switch on the IPC subsystem of the
RPM.
Syntax
show hardware rpm slot-number mac counters [port port-number]
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 65-24. show hardware rpm mac counters Command Example
Table 65-2 defines the fields displayed in Figure 65-24.
slot-number
Enter the RPM slot number 0 or 1.
port port-number (OPTIONAL) Enter the keyword port followed by the port number of the
parity-bus control switch.
Range: 0 to 24
Version 6.5.4.0 Introduced
Table 65-2. show hardware rpm mac counters Command Example Information
Slot ID # Port number on the party-bus control switch.
RX Frames Number of packets received by the party-bus switch from the processor in the specified slot.
TX Frames Number of packets sent by the party-bus switch to the processor in the specified slot.
FTOS#show hardware rpm 0 mac counters
PORT# RX Frames TX Frames
--------------------------------------
0 [LC0 ] 0 5
1 [LC1 ] 25171 2119
2 [LC2 ] 13967 2108
3 [LC3 ] 13964 2108
4 [LC4 ] 0 5
5 [LC5 ] 25134 2108
6 [LC6 ] 0 5
7 [LC7 ] 0 5
8 [LC8 ] 0 5
9 [LC9 ] 0 5
10 [LC10 ] 0 5
11 [LC11 ] 0 5
12 [LC12 ] 0 5
13 [LC13 ] 0 5
20 [LOC-CP ] 23232 101339
21 [LOC-RP1] 5248 1097
22 [LOC-RP2] 5250 1104
23 [UNUSED ] 0 0
24 [REM-RPM] 12617 12630
FTOS#