IPv6 Border Gateway Protocol (IPv6 BGP) | 807
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
The first time you enter this command it configures the neighbor as a route reflector and members of
the route-reflector cluster. Internal BGP (IBGP) speakers do not need to be fully meshed if you
configure a route reflector.
When all clients of a route reflector are disabled, the neighbor is no longer a route reflector.
network
c e
Specify the networks for the BGP process and enter them in the BGP routing table.
Syntax
network ipv6-address [route-map map-name]
To remove a network, use the no network ipv6-address [route-map map-name] command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
The E-Series software resolves the network address configured by the network command with the
routes in the main routing table to ensure that the networks are reachable via non-BGP routes and
non-default routes.
Related
Commands
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 7.4.1.0 Introduced on E-Series TeraScale
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zeros.
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of an established
route map.
Only the following ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all routes).
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 7.4.1.0 Introduced on E-Series TeraScale
redistribute Redistribute routes into BGP.
To Next Page
Loading...
