Dell Force10 TeraScale E Series - Page 968

968 | Multicast
www.dell.com | support.dell.com
Figure 35-7. show mac-address-table static multicast count Command Output
Related
Commands
L2MCIndex Displays the Layer 2 multicast index used to represent a group of outbound interfaces.
The L2 multicast index is a hardware-specific index that is used an internal command
and useful for debugging purposes. Range: 0 - 1023.
Interfaces Displays the interface type and slot/port of output ports assigned to the VLAN used for
Layer 2 multicast forwarding, where the following abbreviations are used for output
port types:
• gi—Gigabit Ethernet slot/port.
• po—Port Channel number
• te—10-Gigabit Ethernet slot/port
Table 35-2. show mac-address-table static multicast Information
Column Heading Description
FTOS#show mac-address-table static multicast count
Static Multicast MAC Entries for all vlans : 3
ip multicast-mode l2 Enable Layer 2 multicast switching.
mac-address-table static Configure a static multicast MAC address, associate the multicast
MAC address with the Layer 2 VLAN used to switch multicast
traffic, and add output ports.