Dell Networking 7048 - Configuring the Static Area Range Cost

Configuring OSPF and OSPFv3 1009
console(config-if-loopback0)#exit
console(config)#exit
Configuring the Static Area Range Cost
Figure 34-39 shows a topology for the configuration that follows.
Figure 34-39. Static Area Range Cost Example Topology
1 Configure R0.
terminal length 0
config
hostname ABR-R0
line console
exec-timeout 0
exit
vlan 101-103
exit
ip routing
router ospf
router-id 10.10.10.10
network 172.20.0.0 0.0.255.255 area 0
network 172.21.0.0 0.0.255.255 area 1
area 1 range 172.21.0.0 255.255.0.0 summarylink
timers spf 3 5
exit
R3
ABR
R0
VLAN 103
Area 0
R1 R2
Area 1
VLAN 104
VLAN 101 VLAN 102