Dell Networking 7048 - Configuring L2 and L3 Relay Features (Web); DHCP Relay Global Configuration

914 Configuring L2 and L3 Relay Features
Configuring L2 and L3 Relay Features (Web)
This section provides information about the OpenManage Switch
Administrator pages for configuring and monitoring L2 and L3 relay features
on a PowerConnect 7000 Series switch. For details about the fields on a page,
click at the top of the page.
DHCP Relay Global Configuration
Use this page to enable or disable the switch to act as a DHCP Relay agent.
This functionality must also be enabled on each port you want this service to
operate on (see "DHCP Relay Interface Configuration" on page 915). The
switch can also be configured to relay requests only when the VLAN of the
requesting client corresponds to a service provider’s VLAN ID that has been
enabled with the L2 DHCP relay functionality (see "DHCP Relay VLAN
Configuration" on page 918).
To access this page, click Switching
→ DHCP Relay → Global
Configuration in the navigation panel.
Figure 33-1. DHCP Relay Global Configuration