Dell Networking 7048 - Configuring Static Lags

Configuring Link Aggregation 835
Configuring Static LAGs
The commands in this example show how to configure a static LAG on a
switch. The LAG number is 2, and the member ports are 10, 11, 14, and 17.
To configure the switch:
1
Enter interface configuration mode for the ports that are to be configured
as LAG members.
console(config)#interface range gi1/0/10-12,
gi1/0/14,gi1/0/17
2
Add the ports to LAG 2 without LACP.
console(config-if)#channel-group 2 mode on
3
View information about LAG 2.
console#show interfaces port-channel 2
Channel Ports Hash Algorithm Ch-Type min-links
------- ----------------- -------------- ------- ---------
Po2 Inactive: Gi1/0/10,
Gi1/0/11, Gi1/0/12,
Gi1/0/14, Gi1/0/17
3 Static 1