Dell Networking 7048 - Ospfv2 Trap Flags

302 Configuring SNMP
OSPFv2 Trap Flags
The OSPFv2 Trap Flags page is used to specify which OSPFv2 traps you want
to enable or disable. When the condition identified by an active trap is
encountered by the switch, a trap message is sent to any enabled SNMP Trap
Receivers, and a message is written to the trap log.
To access the OSPFv2 Trap Flags page, click Statistics/RMON
→ Trap
Manager
→ OSPFv2 Trap Flags in the navigation panel.
Figure 12-16. OSPFv2 Trap Flags