Dell Networking 7048 - 6 Default Settings

Default Settings 117
6
Default Settings
This section describes the default settings for many of the software features
on the PowerConnect 7000 Series switches.
Table 6-1. Default Settings
Feature Default
IP address None
Subnet mask None
Default gateway None
DHCP client Enabled on out-of-band (OOB) interface.
VLAN 1 Members All switch ports
SDM template Dual IPv4 and IPv6 routing
Users None
Minimum password length 8 characters
IPv6 management mode Enabled
SNTP client Disabled
Global logging Enabled
Switch auditing Disabled
CLI command logging Disabled
Web logging Disabled
SNMP logging Disabled
Console logging Enabled (Severity level: warnings and
above)
RAM logging Enabled (Severity level: Informational
and above)
Persistent (FLASH) logging Disabled
DNS Enabled (No servers configured)