Dell Networking 7048 - Default General System Information

Managing General System Settings 245
Default General System Information
By default, no system information or time information is configured, and the
SNTP client is disabled. The default SDM Template applied to the switch is
the Dual IPv4-IPv6 template.
The following table shows the default PoE Plus settings for the
PowerConnect 7024P and 7048P switches.
Table 11-5. PoE Plus Key Features (7024P and 7048P Only)
Feature Description
Global Usage Threshold 96%
Per-Port Admin Status Auto
Per-Port Power Prioritization Enabled (globally, per-port priority is Low
Per-Port Power Limit None
Power Management Mode Dynamic
Power Detection Mode 802.3af Only
Powered Device (PD) Disconnection
Detection Mode
AC
Power Pairs alternative-a