Dell Networking 7048 - Page 753

Configuring L2 Multicast Features 753
mvr querytime time Set the MVR query response time. The value for time is in
units of tenths of a second.
mvr mode {compatible |
dynamic}
Specify the MVR mode of operation.
mvr group mcast-address
[
groups ]
Add an MVR membership group.
• mcast-address —The group IP multicast address
•
group —Specifies the number of contiguous groups
interface interface Enter interface configuration mode for the specified port.
The
interface variable includes the interface type and
number, for example gigabitethernet 1/0/3.
You can also specify a range of ports with the interface
range command, for example, interface range
gigabitethernet 1/0/8-12 configures interfaces 8, 9, 10, 11,
and 12.
mvr Enable MVR on the port.
mvr immediate Enable MVR immediate leave mode on the port.
mvr type {source |
receiver}
Specify the MVR port type.
mvr vlan
vlan-id group
mcast-address
Allow the port to participate in the specified MVR group.
The
vlan-id parameter is the ID of the MVR multicast
VLAN.
CTRL + Z Exit to Privileged EXEC mode.
show ip dhcp snooping
[interfaces]
View the DHCP snooping global and per port
configuration.
show ip dhcp snooping
binding [{static |
dynamic}] [interface
port ] [vlan vlan-id ]
View the entries in the DHCP snooping bindings database.
show mvr View information about the administrative mode of MVR.
show mvr members View information about MVR groups and their members.
show mvr interface
interface
View information about the MVR configuration for a
specific port.
show mvr traffic View information about IGMP traffic in the MVR table.
Command Purpose