Dell Networking 7048 - Page 981

Configuring OSPF and OSPFv3 981
area area-id default-cost
integer
Configure the metric value (default cost) for the type 3
summary LSA sent into the stub area. Range:
1–16777215)
area
area-id nssa Create an NSSA for the specified area ID.
area
area-id nssa no-
summary
Configure the NSSA so that summary LSAs are not
advertised into the NSSA.
area area-id nssa
translator-role {always |
candidate}
Configure the translator role of the NSSA.
• always — The router assumes the role of the translator
when it becomes a border router.
•
candidate — The router can participate in the translator
election process when it attains border router status.
area area-id nssa
translator-stab-intv
integer
Configure the translator stability interval of the NSSA.
The
integer variable is the period of time that an elected
translator continues to perform its duties after it
determines that its translator status has been deposed by
another router. (Range: 0–3600)
area area-id nssa default-
information-originate
[metric metric-value ]
[metric-type
metric-type-
value
]
Configure the metric value and type for the default route
advertised into the NSSA. The metric type can be
comparable (nssa-external 1) or non-comparable (nssa-
external 2).
area
area-id nssa
no-redistribution
Prevent learned external routes from being redistributed
to the NSSA.
exit Exit to Global Config mode.
exit Exit to Privileged EXEC mode.
show ip ospf area
area-id View the configuration and status of an OSPF area.
Command Purpose