Dell PowerEdge C6220 II - Page 120

120 | Using the System Setup Program
Token
Setup option
Description
008C
Embedded USB
Controller
Causes the BIOS to enable the built-in USB controller at
system startup.
008D
Embedded USB
Controller
Causes the BIOS to disable the built-in USB controller at
system startup.
00A1
Restore on AC
Power Loss
After an AC power loss, when AC power is restored, the
system will stay off.
00A2
Restore on AC
Power Loss
After an AC power loss, when AC power is restored, the
system will return to the state was in when power was lost.
00A3
Restore on AC
Power Loss
After an AC power loss, when AC power is restored, the
system will power on.
00BA
Embedded NIC2
Disable the system’s secondary embedded network
interface controller.
00BB
Embedded NIC2
Enable the system’s secondary embedded network
interface controller, but don’t enable the
NIC’s associated
PXE or RPL boot-ROM.
00BC
Embedded NIC2
Enable the system’s secondary embedded network
interface controller (full-function), including
its PXE
boot-ROM.
00BF
Remote Access
Serial Console Redirection Off.
00C0
Serial port
number
Serial Console Redirection On, output to COM1. See also
token D7h.
00C1
Power Button
Default, Enables Power Button to turn off system.
00C2
Power Button
Disables Power Button to turn off system.
00D1
Hyper-Threadin
g Technology
Enables Hyper-Threading Technology.
00D2
Hyper-Threading
Te chnology
Disables Hyper-Threading Technology.
00D7
Serial port
Number
Serial Console redirection ON - output to COM2.