Dell PowerEdge C6220 II - Page 241

Removing and Installing System Components | 241
See “Removing the LSI 9265-8i RAID battery Assembly” on page 210.
Locate the memory module sockets. See Figure 3-64.
CAUTION: Handle each memory module only on either card edge, making sure not
to touch the middle of the memory module. To avoid damaging components on the
memory module, remove only one memory module at a time.
4 Simultaneously press down and out on the ejectors at both ends of the
memory module socket until the memory module is released from the
socket. See Figure 3-64.
5 Lift the memory module out of the socket by contact only at the ends
of the module. See Figure 3-64.
Figure 3-64. Removing a Memory Module
1
memory module
2
memory module socket ejector
(2)