286 | Removing and Installing System Components
4 Replace the screws that secure the front-panel assemblies to the chassis.
See Figure 3-96.
5 Connect all the cables to the backplane. See Figure 3-93 for 3.5-inch
hard drives and Figure 3-94 for 2.5-inch hard drives.
You must route these cables properly through the tabs on the chassis to
prevent them from being pinched or crimped.
6 Connect front panel cables to the power distribution board. See Figure
3-108. You must route these cables properly on the chassis to prevent
them from being pinched or crimped.
7 Replace the screws that secure the hard-drive cage. See Figure 3-95.
8 Close the system, see “Closing the System” on page 152.
9 Replace the hard drives. See “Installing a Hard Drive into a Hard-Drive
Carrier” on page 163.
10 Reconnect the system to its electrical outlet and turn on the system,
including any attached peripherals.
To Next Page
Loading...
