Removing and Installing System Components | 299
3 Replace the screws that secure the front-panel assembly to the hard-
drive cage. See Figure 3-105.
4 Replace the hard-drive cage into the chassis. See Figure 3-96.
5 Replace the screws that secure the front-panel assemblies to the chassis.
See Figure 3-96.
6 Replace the screws that secure the hard-drive cage to the chassis. See
Figure 3-95.
7 Connect front panel cables to the power distribution board. See Figure
3-108 or Figure 3-111.
You must route these cables properly on the chassis to prevent them
from being pinched or crimped.
8 Connect all the cables to the backplane. See Figure 3-93 for 3.5-inch
hard drives and Figure 3-94 for 2.5-inch hard drives.
You must route these cables properly on the chassis to prevent them
from being pinched or crimped.
9 Close the system. See “Closing the System” on page 152.
10 Replace the hard drives. See “Installing a Hard Drive into a Hard-Drive
Carrier” on page 163.
11 Reconnect the system to its electrical outlet and turn on the system,
including any attached peripherals.
To Next Page
Loading...
