Figure 117. Removing the GPU from Riser 4
2. If removing the GPU permanently, install a filler bracket.
NOTE:
You must install a filler bracket over an empty expansion card slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in
proper cooling and airflow inside the system. The filler bracket is necessary to maintain proper thermal conditions.
3. Install a metal filler bracket over the empty expansion slot opening and close the expansion card latch.
Next steps
1. Replace the GPU.
Installing a GPU
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the support bar.
4. Remove the air shroud top cover.
5. Remove the cooling fan cage assembly.
6. Remove the full length expansion card riser.
NOTE: See cable routing section for more information.
CAUTION: Do not install GPUs, network cards, or other PCIe devices on your system that are not validated
and tested by Dell. Damage caused by unauthorized and invalidated hardware installation will null and void the
system warranty.
WARNING: Consumer-Grade GPU should not be installed or used in the Enterprise Server products.
CAUTION: Do not mix the GPUs, as all the installed GPUs must be of the same type and model.
Steps
1. If installed, remove the filler bracket.
148
Installing and removing system components
To Next Page