Dell PowerEdge R960 - Ports and Connectors Specifications; USB Ports Specifications; NIC Port Specifications; Serial Connector Specifications

Infrastructure > Storage Adapters & Controllers > Dell PowerEdge Express Flash NVMe PCIe SSD > Select This
Product > Documentation > Manuals and Documents.
Ports and connectors specifications
USB ports specifications
Table 16. PowerEdge R960 USB specifications
Front Rear Internal (Optional)
USB port type No. of ports USB port type No. of ports USB port type No. of ports
USB 2.0-
compliant port
One USB 2.0-
compliant port
One Internal USB 3.0-
compliant port
One
iDRAC Direct port
(Micro-AB USB
2.0-compliant
port)
One USB 3.0-
compliant port
One
NOTE: The micro USB 2.0 compliant port can only be used as an iDRAC Direct or a management port.
NIC port specifications
The PowerEdge R960 system supports up to two Network Interface Controller (NIC) ports embedded on the LAN on
Motherboard (LOM) card and up to four ports integrated on the Open Compute Project (OCP) card.
Table 17. NIC port specification for the system
Feature Specifications
LOM card (optional) 1 GbE x 2
OCP card (OCP 3.0) (optional) 1GbE x 4, 10 GbE x 2, 10 GbE x 4, 25 GbE x 2, 25 GbE x 4
NOTE: The system allows either LOM card or an OCP card or both to be installed in the system.
Serial connector specifications
The PowerEdge R960 system supports one optional card type serial connector, which is a 9-pin connector, Data Terminal
Equipment (DTE), 16550-compliant.
The optional serial connector card is installed similar to an expansion card filler bracket.
VGA ports specifications
The PowerEdge R960 system supports DB-15 VGA port on front panel and on rear I/O board (optional for Direct Liquid Cooling
configuration).
Video specifications
The platform supports the following video resolution and refresh rates:
Technical specifications
31