Steps
1. Press the tabs to release the side wall cable holder.
NOTE: Move the cables out of the side wall cable holder and observe the cable routing.
2. Press the center tab to release the bracket from the chassis, and lift it away from the system.
Figure 57. Removing the side wall bracket
Next steps
1. Replace the side wall bracket.
Installing the side wall bracket
There are two side wall brackets on either side of the system. The procedure to install is similar.
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the support bar.
4. Remove the air shroud top cover.
5. Remove the cooling fan cage assembly.
6. If required, remove the air shroud or remove the GPU air shroud.
Steps
1. Align the guide slots on the side wall bracket with the guides on the system and slide until the cover is seated firmly.
NOTE: Route the cables through the side wall cable holder properly to prevent the cables being pinched or crimped.
2. Close the side wall cable holder until the holder clicks into place.
Installing and removing system components
95
To Next Page
Loading...
