Dell PowerEdge R960 - Drives; Removing a Drive Blank

Figure 45. Installing the riser air shroud
Next steps
1. Install the expansion card risers or install the full length expansion card riser.
2. IF removed, install the air shroud
3. Install the cooling fan cage assembly.
4. Install the air shroud top cover.
5. Install the support bar.
6. Follow the procedure listed in After working inside your system.
Drives
Removing a drive blank
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. If installed, remove the front bezel.
CAUTION: To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
Steps
Press the release button, and slide the drive blank out of the drive slot.
Installing and removing system components
85