Dell PowerEdge T360 - Chapter 8: Upgrade Kits; BOSS-N1 Module Kit

Upgrade Kits
The table lists the available After Point Of Sale [APOS] kits.
Table 65. Upgrade kits
Kits Related links to service instructions
Memory modules See Installing the memory module
SSDs See Installing the SSDs
GPU See Installing the GPU
Processors See Installing the processor
Heat sink See Installing the heat sink
Storage controller cards See Installing the expansion card into the expansion card slots
HBA
Network cards
Power supplies See Installing the power supply units
Cables See Cable routing
Bezel See Installing the bezel
Power cords N/A
BOSS N1 See Installing an BOSS N1 module
Topics:
• BOSS-N1 module kit
• GPU kit
BOSS-N1 module kit
The BOSS-N1 module supports up to two M.2 NVMe SSDs.
Before you begin the installation or removal process, follow the safety guidelines and before working inside the system
instructions.
Table 66.
BOSS-N1 module kit components
Components in kit T360 (quantity)
BOSS-N1 controller card module 1
BOSS-N1 card carrier 1 or 2*
M.2 NVMe SSD 1 or 2*
M.2 NVMe SSD capacity label 1 or 2
†
BOSS-N1 card carrier blank 1
M3 x 0.5 x 4.5 mm screws 1
BOSS-N1 signal cable for mother board (360 mm) 1
BOSS-N1 power cable for mother board (340 mm) 1
8
Upgrade Kits 129