Initial system setup and configuration
This section describes the tasks for initial setup and configuration of the Dell system. The section also provides general steps to
set up the system and the reference guides for detailed information.
Topics:
• Setting up the system
• iDRAC configuration
• Resources to install operating system
Setting up the system
Perform the following steps to set up the system:
Steps
1. Unpack the system.
2. Connect the peripherals to the system and the system to the electrical outlet.
3. Power on the system.
For more information about setting up the system, see the Getting Started Guide that is shipped with your system.
NOTE:
For information about managing the basic settings and features of the system, see the Pre-operating system
management applications chapter.
iDRAC configuration
The Integrated Dell Remote Access Controller (iDRAC) is designed to make you more productive as a system administrator and
improve the overall availability of Dell servers. iDRAC alerts you to system issues, helps you to perform remote management, and
reduces the need for physical access to the
system.
Options to set up iDRAC IP address
To enable communication between your system and iDRAC, you must first configure the network settings based on your
network infrastructure. The network settings option is set to DHCP, by default.
NOTE: For static IP configuration, you must request for the settings at the time of purchase.
NOTE: To access iDRAC, ensure that you connect the Ethernet cable to the iDRAC dedicated network port or use the
iDRAC Direct port by using the micro USB (type AB) cable. You can also access iDRAC through the shared LOM mode, if
you have opted for a system that has the shared LOM mode enabled.
Options to log in to iDRAC
To log in to the iDRAC Web User Interface, open a browser and enter the IP address.
You can log in to iDRAC as:
● iDRAC user
● Microsoft Active Directory user
● Lightweight Directory Access Protocol (LDAP) user
4
Initial system setup and configuration 29
To Next Page