Dell PowerEdge T360 - Drives; Removing a Drive Blank

Figure 23. Installing the intrusion switch module
Next steps
1. Install the air shroud.
2. Follow the procedure that is listed in After working inside your system.
Drives
Removing a drive blank
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the front bezel.
CAUTION: To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
CAUTION: Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Steps
Press the release button, and slide the drive blank out of the drive slot.
Installing and removing system components
65